A furnace that won't ignite, short-cycles, or keeps tripping its limit switch needs more than a reset in Idaho City winters. Every visit includes a carbon monoxide safety check, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. We test with real equipment, not parts-cannon guessing.
Safety and accuracy on every heating call.
A combustion analyzer reading for dangerous CO levels is part of every visit, not optional.
We bump no-heat calls ahead of routine visits when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Our techs are trained equally on gas furnaces and electric heat strips, no exceptions.
Six repairs that cover most of our winter calls.
These two parts are behind most no-heat visits, usually a same-visit fix.
We test actual response and pressure output rather than replacing an expensive part on a hunch before we recommend replacing it.
A cracked heat exchanger can leak combustion byproducts into the airflow — we inspect with a scope and analyzer rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older Idaho City furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
What happens from your call to heat restored.
Describe the symptom and we route the nearest tech and we'll get someone moving.
A stocked truck arrives ready to diagnose and often repair same visit.
Combustion analysis happens before any repair is quoted, then a flat-rate quote.
Most repairs finish same visit, with a final CO check before we leave, backed by warranty.
Feedback from completed furnace repairs.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
Clicking without ignition often points to the ignitor, but we confirm with a resistance test before quoting.
It's a real safety concern, taken seriously.
A CO check is standard on every call, no upcharge.
Yes — thermocouple and draft-related repairs are covered.
No-heat calls get priority routing, usually same-day even during high demand.
Uncommon parts might mean a follow-up visit to finish the repair.
Our furnace repair coverage spans Idaho City and nearby Idaho City, ID zips below — call to confirm.
Confirm Coverage
